High Weight Compressor Case Study

1430 Words6 Pages
High weight compressor: The air from the low weight compressor comes into the high weight compressor which is the center of the motor and the target of it is to pack the air promote and send it forward to the ignition chamber, the GE-nx has the most productive center which has 10 organize high weight compressors which is lesser then the past motor which utilized 14 stages, and as the quantity of stages reduction that implies less parts less cost and less upkeep. The Pressure proportion given by this module is 23:1. The compressor uses circles and edges which are one piece or one section for different stages, for example, first and second which wipes out and dove-tail wear on them furthermore the fueled compound plates augment the lives of the restricted life parts. Burning chamber: The compacted air from the HPC is guided towards the ignition chamber where this high weight air is warmed and sent towards the turbine. The ignition chamber utilized as a part of the GE-nx is a Twin Annular pre twirl burning chamber that encourages the fuel and air blend to blaze at lower temperatures which minimizes the arrangement of nitrogen oxide and carbon monoxide and in addition unburned…show more content…
In GEnx there is a framework made to defeat this and decrease the harm cause by garbage which causes cutting edge disintegration. The motor is intended to coordinate the majority of the flotsam and jetsam or remote material to the by-pass instead of the compressor. The fan spinner additionally coordinates this material into the air stream while some other of the remaining goes into the air stream through the variable detour valve entryway. This aides in better existence of the cutting edges and less
Show More
Related

  • Essay On Air Brake System

    4893 Words  | 20 Pages

    partial increase in pressure dictates a proportional release in brakes. The following components are exclusive to a foundation air-brake system in a truck or a bus: • Air compressor: Pumps the air into storage tanks to be used in the brake system • Air compressor governor: Controls the cut-in and cut-out point of the air compressor to maintain a set amount of air in the tank or tanks • Air reservoir tanks: Hold compressed or pressurized air to be used by the braking system • Drain valves: Release valves

    Read More

  • Slitting Machine Project Report

    3643 Words  | 15 Pages

    SVKM’s Narsee Monjee Institute of Management Studies Mukesh Patel School of Technology Management and Engineering FINAL REPORT ON IMPROVEMENT FOR DLITTING MACHINE PRODUCTION AND IMPLEMENTATION OF TPM By Sagar Puri Roll Number: 620 SAP Number: 71207100019 Faculty Mentor Prof. Dr. Jinu Kurian Industry Mentor Mr. M.F. Kanade A REPORT ON IMPROVEMENT FOR DLITTING MACHINE PRODUCTION AND IMPLEMENTATION OF TPM By Sagar Puri Roll Number: 620 SAP Number: 71207100019 A report

    Read More

More about High Weight Compressor Case Study

Open Document